Sun-microsystems 1500 Manual do Utilizador

Sun Microsystems, Inc.4150 Network CircleSanta Clara, CA 95054 U.S.A.650-960-1300Send comments about this document to:[email protected] Blade™ 15

11-16 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • April 2003FIGURE 11-15 Pressing Down on the Clip Latchb. Slide the clip to unh

11-22 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • April 200311.3.1 Identifying the BatteryFIGURE 11-23 shows the location of and

11-36 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • April 2003FIGURE 11-34 Identifying the PCI Card Slots3. Swing out the PCI card

Chapter 11 Replacing the Motherboard and Associated Components 11-45FIGURE 11-42 Removing Cables From the Routing Clips9. Disconnect the power and sig

Chapter 13 Replacing Chassis Components 13-45FIGURE 13-48 Removing the PCI Card SupportNote – Do not use the chassis cross brace as a handle.Proceed t

Chapter 15 Finishing Component Replacement 15-9FIGURE 15-8 Reconnecting the Keyboard, Mouse, Monitor, and Network Connections2. Reconnect any other ex

Chapter 11 Replacing the Motherboard and Associated Components 11-3FIGURE 11-1 DIMM Location and IdentificationDepending upon the configuration of you

Chapter 13 Replacing Chassis Components 13-15You can also view an animated version of these instructions by clicking onthis film icon.13.3.1 Identifyi

12-16 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • April 2003FIGURE 12-13 Smart Card Reader Location and Identification12.3.2 Rem

Chapter 14 Replacing Internal Cables 14-714.2.1 Identifying the DVD-ROM Drive Interface CableThe DVD-ROM has separate power and interface cables. The

Chapter 14 Replacing Internal Cables 14-153. Disconnect the IDE power cables from the upper hard drive HDD0.SeeFIGURE 14-12.FIGURE 14-12 Disconnecting

14-10 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • April 200314.3 Replacing the Hard Drive InterfaceCableThis section describes r

Chapter 11 Replacing the Motherboard and Associated Components 11-5FIGURE 11-3 Pressing the Catch on the Rear Fan Bracket4. Slide the duct up until it

Chapter 10 Preparing to Replace Components 10-15FIGURE 10-9 Bezel Location and Identification3. Release the lower mounting tabs.Carefully move the low