Sun-microsystems SUN STOREDGETM 5310 NAS Manual do Utilizador descarregar pdf (Página 235)

100

101

Chapter 3 Storage Arrays 3-35

6. Repeat step 4 and step 5 to install each new drive.

FIGURE 3-19 Removing and Installing a Drive

7. Based on the status of the Active and Fault lights, choose one of the following

steps:

■ Active lights are on while Fault lights are off - Go to step 9.

■ Active lights are off while Fault lights are off - The drive may be installed

incorrectly. Remove the drive, wait 30 seconds, and then reinstall it. Go to step 8.

■ Fault lights are on - The new drive may be defective. Replace it with another new

drive, and then go to step 8.

8. Did this correct the problem?

■ Yes - Go to step 9.

■ No - Select the Recovery Guru toolbar button in the Array Management Window

and complete the recovery procedure. If the problem persists, contact technical

support.

9. Check the module status using the storage management software.

Select the appropriate component button for each module in the Physical View of the

Array Management Window to view the status of its components. The status for

each component will be either Optimal or Needs Attention.

10. Does any module component have a Needs Attention status?

■ Yes - Go to step 11.

■ No - Go to step 12.

11. To run the Recovery Guru, select the Recovery Guru toolbar button in the Array

Management Window.

1 2 ... 230 231 232 233 234 235 236 237 238 239 240 ... 381 382

Comentários a estes Manuais

Sem comentários

Sun-microsystems SUN STOREDGETM 5310 NAS Manual do Utilizador Página 235

Comentários a estes Manuais

Manuais e produtos relacionados com Computadores Sun-microsystems SUN STOREDGETM 5310 NAS