Sun-microsystems Ethernet PCI-X Adapter Manual do Utilizador descarregar pdf (Página 63)

Appendix B Diagnostic Software 47

Using the SunVTS netlbtest

You must have the Ethernet card and the device driver installed, a loopback

connector in place, and Intervention mode enabled before running netlbtest.

netlbtest cannot run if the network interface is connected to a live network, and

requires that the Ethernet device be configured offline before running the test. Use

the ifconfig(1M) command to bring the Ethernet device down before running

netlbtest.

▼ To Use the netlbtest

1. Ensure that the SunVTS software and the ixge driver are installed on your

system.

2. Plug in a loopback cable.

3. Unplumb the interface from the system, using the ifconfig command:

Where

instance is the instance number of the interface.

Refer to SunVTS documentation for instructions on how to run netlbtest.

# ifconfig ixgeinstance down

# ifconfig ixgeinstance unplumb

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 77 78

Sem comentários

Sun-microsystems Ethernet PCI-X Adapter Manual do Utilizador Página 63