
2-1
InstallingtheSunFastEthernet
SBusCard
2
2.1 CardInstallation
1. Remove the SunFastEthernet Adapter card from the antistatic bag and
spread the bag on a firm surface to provide a protective mat.
Figure 2-1 Handling the SunFastEthernet Adapter Card
2. Place the card, component side up, on the bag.
3. Install the card according to the SBus installation procedures in the
hardware installation or service manual for your system.
Note – If a SunFastEthernet card is installed in a slot and you later change the
location of the card, then you must perform the procedure indicated in
Section 2.4, “Relocating a SunFastEthernet Card (Solaris 2.x Only)”.
4. Following card installation, connect to a network.
Comentários a estes Manuais