Sun-microsystems Ethernet MMF/UTP Adapter Manual do Utilizador descarregar pdf (Página 75)

Chapter 3 Configuring ipge and e1000 Driver Parameters 41

▼ To Configure Jumbo Frames Using ndd

1. Shut down and unplumb the interface.

2. Set the instance number:

In this example, the instance number set is 0.

3. Set the instance to accept Jumbo Frames:

4. Plumb the interface up:

where

xx.xx.xx.xx is the IP address of the interface.

▼ To Configure Jumbo Frames in a Linux

Environment

1. Ensure that the e1000 software is installed.

2. Plumb the Sun PCI-Express Dual Gigabit Ethernet interface:

where

xxx.xxx.xx.xxx is the IP address of the interface.

3. Set the MTU for maximum performance:

% ndd -set /dev/ipge instance 0

% ndd -set /dev/ipge accept-jumbo 1

% ifconfig ipge0 plumb xx.xx.xx.xx up

# modprobe e1000

# ifconfig eth2 xxx.xxx.xx.xxx up

# ifconfig eth2 mtu 8170

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 121 122

Sem comentários

Sun-microsystems Ethernet MMF/UTP Adapter Manual do Utilizador Página 75